Quick Clamping Tooling: Hydraulic Clamping System for Production
This hydraulic clamping device is mainly used for batch processing of plate parts such as molds, and is particularly suitable for rapid clamping of mold parts and machined components.
Compared with the general fixtures, there is no need to calibrate the level one by one or to calibrate the table repeatedly. Using two symmetrical right-angled edge positioning, accurate positioning, it can achieve one-time calibration and repeated use.
Overview of Hydraulic Clamping System
Components
- Positioning parts: Forward positioning strip, lateral positioning strip.
- Safety hook kit: Support, hook, hook latch, hook platen, etc.
- Pinch parts: T-slot rail, rack, base, pad stop, locking rack, etc.
Applicable equipment
MD-1270 and all kinds of machining center workbenches for clamping, etc.
Features
Consider the design of anti-dumbness, to ensure the personal safety of the operator and avoid the parts wrongly loaded, less loaded, etc.
Improve the production efficiency, reduce the cost for the factory, improve machine tool utilization, and reduce burden on operators.
Fully consider the applicability, practicality, operability, and output stability of the fixture.
The clamping force and clamping stroke can be adjusted within a certain range, and the clamping action is quick.
Advantages
ASIATOOLS hydraulic fixture has the following advantages compared with traditional clamping methods:
One-time calibration
Our hydraulic clamps can achieve one-time calibration and repeated use, does not require repeated calibration.
High clamping accuracy and efficiency
After clamping, the calibration tolerance can be achieved within 0.05mm.
Automated programming
Reduce the risk of operators and programmers colliding with fixture, allowing the tool to freely move in the plate surface, largely improving programming efficiency.
Extended service life
Reduced the frequency of collisions ensures the accuracy of the machine tools.
Enhanced work efficiency
Reduce the time it takes for operators to find the proper fixture. Simply push it forward, greatly reduce the clamping time and improving work efficiency, regardless of whether the thickness of the plate is even.
No damage to workpieces
The side press clamping will not damage the appearance of the workpiece, unlike the general fixture that usually leaves marks.
Time and effort saving
It helps save time and effort, no longer needing to use a force rod that requires a lot of physical strength, resulting in back pain and soreness after a shift.